mibs/MIBS/cisco/CISCO-MEMORY-POOL-MIB

476 lines
16 KiB
Plaintext
Raw Permalink Normal View History

2023-12-05 12:25:34 +01:00
-- *****************************************************************
-- CISCO-MEMORY-POOL-MIB
--
-- February 1996, Jeffrey T. Johnson
--
-- July 2001, Seth Wang
--
-- Copyright (c) 2001, 2013 by cisco Systems Inc.
-- All rights reserved.
-- *****************************************************************
CISCO-MEMORY-POOL-MIB DEFINITIONS ::= BEGIN
IMPORTS
MODULE-IDENTITY,
OBJECT-TYPE,
Integer32,
Gauge32,
NOTIFICATION-TYPE
FROM SNMPv2-SMI
MODULE-COMPLIANCE,
OBJECT-GROUP,
NOTIFICATION-GROUP
FROM SNMPv2-CONF
TEXTUAL-CONVENTION,
DisplayString,
TruthValue
FROM SNMPv2-TC
Percent
FROM CISCO-QOS-PIB-MIB
ciscoMgmt
FROM CISCO-SMI;
ciscoMemoryPoolMIB MODULE-IDENTITY
LAST-UPDATED "201309180000Z"
ORGANIZATION "Cisco Systems, Inc."
CONTACT-INFO
"Postal: Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
Tel: +1 408 526 4000
E-mail: cs-snmp@cisco.com"
DESCRIPTION
"MIB module for monitoring memory pools"
REVISION "201309180000Z"
DESCRIPTION
"Added new notification ciscoMemoryPoolLowMemoryNotif.
Added new notification ciscoMemoryPoolLowMemoryRecoveryNotif.
Added new object ciscoMemoryPoolLowMemoryNotifEnable.
Added new object ciscoMemoryPoolLowMemoryNotifThreshold.
Added new group ciscoMemoryPoolGroupRev1 which deprecates
ciscoMemoryPoolGroup.
Added new compliance ciscoMemoryPoolComplianceRev2 which
deprecates ciscoMemoryPoolComplianceRev1."
REVISION "200107310000Z"
DESCRIPTION
"Added a new table, ciscoMemoryPoolUtilizationTable, which
provides information about memory utilization."
REVISION "199602010000Z"
DESCRIPTION
"Initial version of this MIB module."
::= { ciscoMgmt 48 }
CiscoMemoryPoolTypes ::= TEXTUAL-CONVENTION
STATUS current
DESCRIPTION
"Represents the different types of memory pools that
may be present in a managed device. Memory pools can
be roughly categorized into two groups, predefined
pools and dynamic pools. The following pool types
are currently predefined:
1: processor memory
2: i/o memory
3: pci memory
4: fast memory
5: multibus memory
Dynamic pools will have a pool type value greater than
any of the predefined types listed above.
Note that only the processor pool is required to be
supported by all devices. Support for other pool types
is dependent on the device being managed."
SYNTAX Integer32 (1..65535)
ciscoMemoryPoolObjects OBJECT IDENTIFIER
::= { ciscoMemoryPoolMIB 1 }
ciscoMemoryPoolTable OBJECT-TYPE
SYNTAX SEQUENCE OF CiscoMemoryPoolEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"A table of memory pool monitoring entries."
::= { ciscoMemoryPoolObjects 1 }
ciscoMemoryPoolEntry OBJECT-TYPE
SYNTAX CiscoMemoryPoolEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"An entry in the memory pool monitoring table."
INDEX { ciscoMemoryPoolType }
::= { ciscoMemoryPoolTable 1 }
CiscoMemoryPoolEntry ::= SEQUENCE {
ciscoMemoryPoolType CiscoMemoryPoolTypes,
ciscoMemoryPoolName DisplayString,
ciscoMemoryPoolAlternate Integer32,
ciscoMemoryPoolValid TruthValue,
ciscoMemoryPoolUsed Gauge32,
ciscoMemoryPoolFree Gauge32,
ciscoMemoryPoolLargestFree Gauge32,
ciscoMemoryPoolLowMemoryNotifThreshold Percent
}
ciscoMemoryPoolType OBJECT-TYPE
SYNTAX CiscoMemoryPoolTypes
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"The type of memory pool for which this entry
contains information."
::= { ciscoMemoryPoolEntry 1 }
ciscoMemoryPoolName OBJECT-TYPE
SYNTAX DisplayString
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"A textual name assigned to the memory pool. This
object is suitable for output to a human operator,
and may also be used to distinguish among the various
pool types, especially among dynamic pools."
::= { ciscoMemoryPoolEntry 2 }
ciscoMemoryPoolAlternate OBJECT-TYPE
SYNTAX Integer32 (0..65535)
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Indicates whether or not this memory pool has an
alternate pool configured. Alternate pools are
used for fallback when the current pool runs out
of memory.
If an instance of this object has a value of zero,
then this pool does not have an alternate. Otherwise
the value of this object is the same as the value of
ciscoMemoryPoolType of the alternate pool."
::= { ciscoMemoryPoolEntry 3 }
ciscoMemoryPoolValid OBJECT-TYPE
SYNTAX TruthValue
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Indicates whether or not the remaining objects in
this entry contain accurate data. If an instance
of this object has the value false (which in and of
itself indicates an internal error condition), the
values of the remaining objects in the conceptual row
may contain inaccurate information (specifically, the
reported values may be less than the actual values)."
::= { ciscoMemoryPoolEntry 4 }
ciscoMemoryPoolUsed OBJECT-TYPE
SYNTAX Gauge32
UNITS "bytes"
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Indicates the number of bytes from the memory pool
that are currently in use by applications on the
managed device."
::= { ciscoMemoryPoolEntry 5 }
ciscoMemoryPoolFree OBJECT-TYPE
SYNTAX Gauge32
UNITS "bytes"
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Indicates the number of bytes from the memory pool
that are currently unused on the managed device.
Note that the sum of ciscoMemoryPoolUsed and
ciscoMemoryPoolFree is the total amount of memory
in the pool"
::= { ciscoMemoryPoolEntry 6 }
ciscoMemoryPoolLargestFree OBJECT-TYPE
SYNTAX Gauge32
UNITS "bytes"
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Indicates the largest number of contiguous bytes
from the memory pool that are currently unused on
the managed device."
::= { ciscoMemoryPoolEntry 7 }
ciscoMemoryPoolLowMemoryNotifThreshold OBJECT-TYPE
SYNTAX Percent
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"This object is used to indicate the threshold value in
percentage of free memory remaining in a memory pool.
If the free memory available goes below this threshold value and
if ciscoMemoryPoolLowMemoryNotifEnable is set to 'true',
ciscoMemoryPoolLowMemoryNotif will be generated. When the
available free memory comes back to the threshold value
ciscoMemoryPoolLowMemoryRecoveryNotif will be generated."
::= { ciscoMemoryPoolEntry 8 }
ciscoMemoryPoolUtilizationTable OBJECT-TYPE
SYNTAX SEQUENCE OF CiscoMemoryPoolUtilizationEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"A table of memory pool utilization entries. Each of the
objects provides a general idea of how much of the memory
pool has been used over a given period of time. It is
determined as a weighted decaying average."
::= { ciscoMemoryPoolObjects 2 }
ciscoMemoryPoolUtilizationEntry OBJECT-TYPE
SYNTAX CiscoMemoryPoolUtilizationEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"An entry in the memory pool utilization table."
AUGMENTS { ciscoMemoryPoolEntry }
::= { ciscoMemoryPoolUtilizationTable 1 }
CiscoMemoryPoolUtilizationEntry ::= SEQUENCE {
ciscoMemoryPoolUtilization1Min Percent,
ciscoMemoryPoolUtilization5Min Percent,
ciscoMemoryPoolUtilization10Min Percent
}
ciscoMemoryPoolUtilization1Min OBJECT-TYPE
SYNTAX Percent
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"This is the memory pool utilization for 1 minute."
::= { ciscoMemoryPoolUtilizationEntry 1 }
ciscoMemoryPoolUtilization5Min OBJECT-TYPE
SYNTAX Percent
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"This is the memory pool utilization for 5 minutes."
::= { ciscoMemoryPoolUtilizationEntry 2 }
ciscoMemoryPoolUtilization10Min OBJECT-TYPE
SYNTAX Percent
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"This is the memory pool utilization for 10 minutes."
::= { ciscoMemoryPoolUtilizationEntry 3 }
ciscoMemoryPoolLowMemoryNotifEnable OBJECT-TYPE
SYNTAX TruthValue
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"This object is used to enable or disable the generation of
notification when the available memory in the system has fallen
below ciscoMemoryPoolLowMemoryNotifThreshold and on recovery.
Setting this object to 'true' will generate
ciscoMemoryPoolLowMemoryNotif and
ciscoMemoryPoolLowMemoryRecoveryNotif.
Setting this object to 'false' will disable the generation of
ciscoMemoryPoolLowMemoryNotif and
ciscoMemoryPoolLowMemoryRecoveryNotif."
::= { ciscoMemoryPoolObjects 3 }
-- notifications
ciscoMemoryPoolNotifications OBJECT IDENTIFIER
::= { ciscoMemoryPoolMIB 2 }
ciscoMemoryPoolMIBNotificationPrefix OBJECT IDENTIFIER
::= { ciscoMemoryPoolNotifications 0 }
ciscoMemoryPoolLowMemoryNotif NOTIFICATION-TYPE
OBJECTS {
ciscoMemoryPoolName,
ciscoMemoryPoolUsed
}
STATUS current
DESCRIPTION
"This notification is generated when the percentage of free
memory in the system has fallen below
ciscoMemoryPoolLowMemoryNotifThreshold and when the value of
ciscoMemoryPoolLowMemoryNotifEnable is set to 'true'.
ciscoMemoryPoolName indicates the name of the memory pool for
which the notification is being generated.
ciscoMemoryPoolUsed indicates the used memory in bytes for the
memory pool."
::= { ciscoMemoryPoolMIBNotificationPrefix 1 }
ciscoMemoryPoolLowMemoryRecoveryNotif NOTIFICATION-TYPE
OBJECTS {
ciscoMemoryPoolName,
ciscoMemoryPoolUsed
}
STATUS current
DESCRIPTION
"This notification is generated when the percentage of free
memory in the system has returned to
ciscoMemoryPoolLowMemoryNotifThreshold after suffering from a
low memory. This notification is generated when the value of
ciscoMemoryPoolLowMemoryNotifEnable is set to 'true'. This
notification is generated as a recovery notification for
ciscoMemoryPoolLowMemoryNotif.
ciscoMemoryPoolName indicates the name of the memory pool for
which the notification is being generated.
ciscoMemoryPoolUsed indicates the used memory in bytes for the
memory pool."
::= { ciscoMemoryPoolMIBNotificationPrefix 2 }
-- conformance information
ciscoMemoryPoolConformance OBJECT IDENTIFIER
::= { ciscoMemoryPoolMIB 3 }
ciscoMemoryPoolCompliances OBJECT IDENTIFIER
::= { ciscoMemoryPoolConformance 1 }
ciscoMemoryPoolGroups OBJECT IDENTIFIER
::= { ciscoMemoryPoolConformance 2 }
-- compliance statements
ciscoMemoryPoolCompliance MODULE-COMPLIANCE
STATUS deprecated
DESCRIPTION
"The compliance statement for entities which implement
the Cisco Memory Pool MIB"
MODULE -- this module
MANDATORY-GROUPS { ciscoMemoryPoolGroup }
::= { ciscoMemoryPoolCompliances 1 }
ciscoMemoryPoolComplianceRev1 MODULE-COMPLIANCE
STATUS deprecated
DESCRIPTION
"The compliance statement for entities which implement
the Cisco Memory Pool MIB"
MODULE -- this module
MANDATORY-GROUPS { ciscoMemoryPoolGroup }
GROUP ciscoMemoryPoolUtilizationGroup
DESCRIPTION
"Per memory pool utilization statistics is mandatory for
the managed system that supports memory pool utilization."
::= { ciscoMemoryPoolCompliances 2 }
ciscoMemoryPoolComplianceRev2 MODULE-COMPLIANCE
STATUS current
DESCRIPTION
"The compliance statement for entities which implement
the Cisco Memory Pool MIB"
MODULE -- this module
MANDATORY-GROUPS { ciscoMemoryPoolGroupRev1 }
GROUP ciscoMemoryPoolUtilizationGroup
DESCRIPTION
"Per memory pool utilization statistics is mandatory for
the managed system that supports memory pool utilization."
GROUP ciscoMemoryPoolNotificationGroup
DESCRIPTION
"ciscoMemoryPoolNotificationGroup is mandatory for the managed
system that supports memory pool notifications."
GROUP ciscoMemoryPoolNotificationCtrlGroup
DESCRIPTION
"ciscoMemoryPoolNotificationCtrlGroup is mandatory for the
managed system that supports memory pool notifications."
::= { ciscoMemoryPoolCompliances 3 }
-- units of conformance
ciscoMemoryPoolGroup OBJECT-GROUP
OBJECTS {
ciscoMemoryPoolName,
ciscoMemoryPoolAlternate,
ciscoMemoryPoolValid,
ciscoMemoryPoolUsed,
ciscoMemoryPoolFree,
ciscoMemoryPoolLargestFree
}
STATUS deprecated
DESCRIPTION
"A collection of objects providing memory pool monitoring."
::= { ciscoMemoryPoolGroups 1 }
ciscoMemoryPoolUtilizationGroup OBJECT-GROUP
OBJECTS {
ciscoMemoryPoolUtilization1Min,
ciscoMemoryPoolUtilization5Min,
ciscoMemoryPoolUtilization10Min
}
STATUS current
DESCRIPTION
"An optional group providing a collection of memory pool
utilization objects."
::= { ciscoMemoryPoolGroups 2 }
ciscoMemoryPoolNotificationGroup NOTIFICATION-GROUP
NOTIFICATIONS {
ciscoMemoryPoolLowMemoryNotif,
ciscoMemoryPoolLowMemoryRecoveryNotif
}
STATUS current
DESCRIPTION
"A collection of all the notifications supported in the
CISCO-MEMORY-POOL-MIB."
::= { ciscoMemoryPoolGroups 3 }
ciscoMemoryPoolNotificationCtrlGroup OBJECT-GROUP
OBJECTS { ciscoMemoryPoolLowMemoryNotifEnable }
STATUS current
DESCRIPTION
"A collection of all the notification control objects."
::= { ciscoMemoryPoolGroups 4 }
ciscoMemoryPoolGroupRev1 OBJECT-GROUP
OBJECTS {
ciscoMemoryPoolName,
ciscoMemoryPoolAlternate,
ciscoMemoryPoolValid,
ciscoMemoryPoolUsed,
ciscoMemoryPoolFree,
ciscoMemoryPoolLargestFree,
ciscoMemoryPoolLowMemoryNotifThreshold
}
STATUS current
DESCRIPTION
"A collection of objects providing memory pool monitoring."
::= { ciscoMemoryPoolGroups 5 }
END